FatCat Design Studio

07/06/2025

https://fatcatds.etsy.com

07/03/2025

04/21/2025

I recently upgraded my laser cutter/engraver to the MONPORT ONYX 55watt. So much better! Faster, higher definition, more flexible than my old Glow Forge equipment. With the new features I now have access to you can expect new designs and products coming soon

01/12/2025

Visit my Etsy Storefront if you or a friend have made a HOLE IN ONE to purchase a plaque to commemorate your achievement!
https://fatcatds.etsy.com

02/29/2024

I've been specializing in Golf Hole in One plaques, so if you are lucky (skilled?) enough to get one.... check out my Etsy Shop! https://fatcatds.etsy.com

03/08/2022

01/10/2022

Used the pro pass through feature for this. 24”x11”. The software divided it into 3 pieces that aligned perfectly. Set it to engrave 1000 speed 75 power. Took between 1.2 and 1.5 hours for each section. It was slooooow. Worse part was that you can’t tell where the engraving will end on the wood when the job is done dice you only see the section being engraved. Best bet is to use oversized wood then trim it to size when finished. Unless someone knows of a better way.

01/10/2022

Used the pro pass thu feature on this. It aligned perfectly. It took 3 sections to complete this 24”x11” piece. Each section took about 1.2 - 1.5 hours to complete!!! This machine is slooooow. Set the engraving at sp 1000 power 78.

01/07/2021

Visit our Etsy shop to check out our latest creations! https://www.etsy.com/shop/FatcatDS