Arcade Ambulance

08/13/2025

Time to update with a refurbished PC 🤩

08/24/2023

Sooooo....I may have a secret I've been keeping under wraps for a few weeks, but Green Bay now has Initial D Infinity Stage! I'm installing them as we speak at Tundra Lodge's Arcade and will be linked and Initial D card accepting!

We may have the possibility of getting a few other import games in the near future such as Jubeat, Wacca, DDR Gold, and a few others!

08/17/2023

Trying to teach the new RX-8 how to drift for next year 😆

02/17/2023

Goodbye and thanks for the years of service you put in at Tundra Lodge! Happily moving to their new home at Heros Venture Arcade in Two Rivers! Definitely check them out, huge selection of games!

12/20/2022

Angry Birds Coin Crash. One of the most popular coin pushers on the market right now. Also very prone to repairs being needed if powered down in it's "Tower Bonus" mode....8 bolts, 10 screws, 12 nuts, 3 harness connectors unclipped, plus having to lower this mechanism by hand with minimal space with the pre-installed scissor jack....average repair time is 4 hours or less....Don't turn it off mid bonus.

12/13/2022

Sometimes in older Jamma board games (ALOT of Midway and racing games), the game will get stuck in a boot loop of starting, getting thru the test cycle, initialize, then restart or run thru the demo mode for a little bit and then restart.

Dirty pins and harness connector are a usual cause of low voltage to the board causing this to happen. A simple cleaning is all it might take to fix like it did for me, other times it can be a fresh permanent wire soldering to redo the ground for the board.

Glad this one was the easy route, been running stable with no restarting for 2 hours now, whereas it's been progressing further into the boot loop for months (from occasionally, to every few hours every day, to not being able to play for the last 2 weeks) after I did an internal cleaning and couldn't figure out why.

Simple fixes are always a great solution!

10/13/2022

From melted wiring harness from a soda/drink spill in the past, to complete harness rebuild and internal cleaning, to rebuilding siren light and getting the machine back in great working order!

08/31/2022

Machine cleaning is always a must to keep them in great running shape!

06/29/2022

Start to finish progression of LA Machineguns projection screen conversion to 1080p LCD TV

05/25/2022

So been debating on this for a while, but i need to start growing the business, but funds just aren't there to do so, so im looking for a little help so i can start competing with the bigger businesses around....

Hey, Spex/Andrew here. A lot of you know me and know I finally decided in the beginn… Andrew Janssen needs your support for Arcade Ambulance Business Booster

05/25/2022

The game I played today is called "try to find the dead battery causing the calibration issue".... (It took me a while to find it online even!)